Vintage Frigidaire Washer Outer Bellows Pliers - Last New Ones Available!

Sorry! Just Sold Out on these again!

Here's a no-longer-available, extremely hard-to-find tool (I just bought the last ones I could find anywhere in the USA!) for vintage General Motors/Frigidaire clothes washers.  This is Robinaire OEM part # 12071 - the special pliers used to remove and install the large 'water', or outer, bellows seals. Works on both the early 5433576 and later 638860 outer bellows snap rings.

I remember when this job was common - 'wish I had a dollar for every set of bellows I've replaced over the years, and every nail I pulled out of the originals! I think my left leg's still sore from putting it into washer tubs to hold them while I wrestled the agitator nut off to replace these!

This is a 'new old stock', no-longer-available OEM tool, and once these are gone, they're going to be pretty much impossible to find. I have very few of these, so HURRY!

Note I also have a limited quantity of both the large 'outer' bellows and inner 'oil' bellows seals in stock at the moment. It's best to replace both bellows as a set.

Click the button to buy one using Paypal, and I'll ship it immediately, Priority Mail ($5.00 in USA, $42.50 total, plus 6% sales tax if you're in PA):

[SORRY - SOLD OUT!]

If you'd rather order by another method, live outside the US, or have any questions, please feel free to contact me

Thank you!