Rare,
No Longer Available 70's Sunbeam Mixmaster Governor!
Orig.
Sunbeam Part # 86631

Here's an extremely hard to find, no longer available new part - one of the few
that fails with any regularity on the great vintage Sunbeam Mixmaster mixers we
affectionately call 'PlasticMasters', made during the 1970's. They
looked like these:

Some typical service numbers (found on the rectangular beater
ejector, where the beaters insert) are MMA, MMB, 1-7A, 1-8B. Nearly all
the Mixmasters that use this governor have removable cords that plug
into the right side of the motor housing.

When this happens your Mixmaster won't run at all, but is completely
"dead". (The on/off switch contact
arm on the top of these governors fatigues and breaks off). If you don't feel a definite 'snap' when turning it to
'off', then it's a pretty safe bet it's just this contact arm broken
off.
This
is a good/used, tested governor, and it's not hard to replace if you're
just a bit handy with tools. Quantities are always limited, so if you
need one, don't wait!
Ships fast. I'll Priority one to any US address - you'll have it in 2-3
days! I have to get $24.50 plus the $9.00 shipping, $33.50 total -
via Priority (FAST!) shipping & handling!
(6%
sales tax will be added if you're in PA).
Just
click the button below to pay securely, using any credit card, via Paypal.
Please click the option when
checking out to let me know which style you need, 2-wire or 3-wire (see
photo above), or drop me a
quick email.
(You don't need a Paypal
account to pay with your credit card)
If you'd rather order by another method,
live outside the US, or have any questions, please feel free to contact me
Note: I recently finished writing a
service manual for these mixers. Check it out
here
Thank
you!
|